Step 7: Solder your remaining wire to the input pin header (left-most header). Make sure you solder directly to the capacitor pads, and not to the single pads on either side of it. Step 6: Solder the ground and power to the pads of the capacitor located to the bottom left of the processor. Step 5: Add some double sided tape to the location where you wish the mod to live. Step 4: Locate and carefully desolder and remove the Q400 transistor and solder one wire to the single side pad of where the transistor once was. Step 3: Remove the eight screws on the bottom PCB to free it from the transmitter housing. They are located at the top corners of the transmitter and in the bottom corners of the battery bay. Step 2: Remove the four Philips head screws holding the housing together. Step 1: Pull the battery cover off of the transmitter and remove battery.
0 kommentar(er)
